20.50.550 LO-01 – Lot standards.
This lot standards (LO) section applies to the following zoning districts:
CO PR A1 A2 A3 A4 R1 R2 VR M1 M2 MP IS LB GC HC CP I1 I2 HI
The following standards shall apply:
A. Applicability. If a lot standard listed in JCC 20.50.540, Lot standards, does not appear in the section for a specific zoning district, then that standard does not apply to that particular zoning district.
B. Lot Standards.
1. Minimum Dwelling Site Area. The minimum dwelling site area shall be per each section in Chapter 20.20 JCC, Zoning Districts.
2. Minimum Dwelling Site Width. The minimum dwelling site width shall be per each section in Chapter 20.20 JCC, Zoning Districts.
3. Minimum Lot Area. The minimum lot area shall be per each section in Chapter 20.20 JCC, Zoning Districts.
4. Maximum Lot Area. The maximum lot area shall be per each section in Chapter 20.20 JCC, Zoning Districts.
5. Minimum Lot Width. The minimum lot width shall be per each section in Chapter 20.20 JCC, Zoning Districts.
C. Measurement. The minimum lot width shall be measured at the established setback for lots with a primary structure, or for lots with a primary structure under review for approval; and the lot width for undeveloped lots shall be measured at the minimum setback line.
D. Minimum Lot Frontage. The minimum lot frontage shall be seventy-five percent (75%) of the required minimum lot width except for cul-de-sacs which are described as follows.
1. Cul-de-Sac Lots. Lots established around a cul-de-sac bulb shall be required to be at least one-half (½) the required minimum lot width. However, under no circumstances shall the lot frontage be less than twenty-five (25) feet in residential districts or thirty-five (35) feet in all other districts. [Ord. 12-27-11 § 5.55.]